Alnico Powder or Grinding Swarf Section 1 - Product NameProduct Name: Alnico Powder or Grinding Swarf Section 2 - Hazardous IngredientsChemical Name: AluminumMaterial/Component(s): Material or ComponentWeight %CAS No.ACGUH TLV (mg/m^3) Aluminum6-13%7429-90-510 mg/m3 Iron(oxide fume)34-56%1309-37-11 mg/m3 Copper(dust)1-7%7440-50-80.1 mg/m3 Nickel12-29%7440-02-05 mg/m3 Cobalt1-40%7440-48-41 mg/m3 Titanium0-8%N/AN/A Niobium0-2%N/AN/A Section 3 - Physical CharacteristicsBoiling Point: Above 2500° CVapor Pressure: N/AVapor Density: (Air = 1) - N/ASpecific Gravity: 6.9-7.4Melting Point: 1,600° CEvaporation Rate: (Butyl Acetate = 1) N/AOdor: No odorSolubility in Water: InsolubleAppearance: Silver gray powder Section 4 - Fire and Explosion Hazard DataFlash Point: N/AFLAMMABLE LIMITS: N/ALEL: N/AUEL: N/AExtinguishing Media: N/ASpecial Fire Fighting Procedures: N/AUnusual Fire and Explosion Hazards(s): May occur in case of dry, fine grained dust in air. Section 5 - Reactivity DataStability: StableConditions to Avoid: N/AIncompatibility (Materials to Avoid): Strong acids Section 6 - Health Hazard DataHealth Hazards (Acute & Chronic): UnknownEmergency and First Aid Procedures: Procedure ForProcedure Eyes Flush with running water for fifteen minutes, including under eyelids InhalationRemove to fresh air SkinBrush off powder; wash well with soap and water Section 7 - Precautions for Safe Handling and UseSpill Procedure: Pick up powder/dust products. Prevent dusty conditions.Waste Disposal Method: Recycle scrap metal or metal powders. Section 8 Control MeasuresRespiratory Protection: NIOSH approved for particulate (fume, dust, mist)Eye Protection: Protective goggles are recommended because of the materials tendency to chip and break.Skin Protection: Protective Gloves - ClothVentilation: GeneralWork / Hygienic Practices: Follow good industrial hygiene and housekeeping practices. WARNING: RARE EARTH MAGNETS ARE EXTREMELY POWERFUL! They have very strong magnetic forces which make them attract to other magnets and other ferromagnetic materials such as iron or steel. HANDLE WITH EXTREME CAUTION!